81min/2.47m/$0.19
http://www.thingiverse.com/thing:976337
I found this a while ago as part of my wish-list to print so I tried it by reorienting it so that it's back was to the plate and adding supports.
The print looked ok while it was fresh off the late.
But it stuck TOO WELL to the plate. I almost jabbed myself with the scraper trying to get it off. Once it was off the supports stuck too well on the back of the figure. I broke a leg off which was ok because it can be glued back on.
But the back of the figure was impossible to clean up. The supports pretty much merged with it and it was impossible to remove.
No comments:
Post a Comment