151min/6.2m/$0.47
https://www.shapeways.com/product/RJCAAAXW7/wolf?optionId=59691068&li=user-profile
Printing from mz4250's amazing set of free prints again.
I decided to do a whole pack and set it to autoshut off at night.
It worked well but as soon as I tried to lift one off the plate, I broke his legs off!
OOPS! One down right? Nope, I broke a lot more just trying to take off their supports. The feet of these wolves are VERY thinly attached to the base. I eventually just accepted that I will either snap all the legs or at least just the first two. It's ok though, these can be glued back on. It's a great model, just know that you're going to snap legs!
No comments:
Post a Comment